Hobbyzone Carbon Cub S2 Tire/Wheel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement tire and wheel hub for the Hobbyzone Carbon Cub S2.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 688
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I attempted to create a softer tire for the carbon cub to minimize bouncing when landing on hard surfaces. This is definitely softer than the stock tire, but the jury is out on whether or not it minimizes bouncing. It is a small bit heavier than stock as printed and there is a bit more rolling resistance to the wheel hub…which I found I actually liked.
The wheel should just pop into the tire and not require glue. Should also fit nicely onto the stock landing gear assembly.
Printed with 95A TPU, 4% gyriod infill. Wheel was printed with 20% infill in PETG.
I can't say it's a notable improvement over the stock setup, but if you happen to need some new tires here you go!