Worker Seagull Koda magazine fix

A fix for the Worker Seagull that raises the magazine higher to prevent collision between the feedlips and the pusher O ring, especially when using Koda(likely Tachi as well) magazines. 

Requires significant modification of the dart gate, and a little bit of shell cutting.
 

Tools:

• Dremel/hacksaw/etc for cutting dart gate
• Pliers for bending dart gate
• Flush cutters or similar for expanding mag release hole in shell
• File and a sharp knife for cleanup
   

The Hard Part:

Hacking up the dart gate

Firstly, cut your dart gate  following the end of the chamfer, such that you make it have two tabs. Mine is a little rough, try and make them straighter than I did. Then, just bend the tabs up to form a flat line, then a slight W shape to allow the mag to go higher than normal.

Clean it up with a file, MAKE SURE THERE ARE NO PROTRUSIONS. They'll catch on the magazine and get hung up on insertion and removal.

The easier parts:

Trimming the shell, and printing the part

Not too complicated. Cut ~2mm from the top edge of the hole the mag release pokes through on both sides of the shell, just enough to fit the new mag release print, which just drops in.

Clean up with an exacto knife or similar so that the mag release can move freely.

Close the blaster up and test fit. If the mag takes force to catch, the dart gate probably needs to be bent higher to allow the feed lips more clearance. If the mag can go a lot higher than the catch, the gate is bent too high.

Have fun not ruining your pusher O ring seal, and having a smoother prime.