Ambient Rain Gauge Coil
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement coil for an Ambient WS-5000 Rain Gauge to avoid bird droppings inside the unit.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 323
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Rain gauges need something to prevent birds from perching like metal prongs around the top, but some designs are not always effective. A filter can help prevent their droppings and other small wind-blown debris from getting inside the unit, which otherwise is hard to clean.
This part replaces the metal rain gauge coil that comes with an Ambient WS-5000 rain gauge, which I lost when it launched into the grass. This printed version is shown upside down and it clips into the hole at the bottom of the gauge funnel.
I printed with PLA, but may change it down the road to PETG for withstanding the weather better. I used a .20 mm layer height and .60 mm nozzle for a quick 9 minute print. This needs supports for the clip. The support is very tiny and I had to cut it out with a small pair of diagonal cutters.
This model is based on an OpenSCAD module by MANTICORP published on Cults3D at:
https://cults3d.com/en/3d-model/various/archimedean-spiral-module