Voron NozzleProbe for CR10/CR10s PRO
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have made a mod of the VORON NozzleProbe housing for my CR10s PRO.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 460
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- GNU General Public License v2.0
Please connect the end stop connector to cr10s pro board z_max and set the klipper config as following:
[stepper_z]
step_pin: PL3 #ar46
dir_pin: !PL1 #!ar48
enable_pin: !PK0 #!ar62
rotation_distance: 8
microsteps: 16
full_steps_per_rotation: 200
#endstop_pin: probe:z_virtual_endstop
endstop_pin: PD2
#position_endstop: 0
position_min: -10
position_max: 351 # you can go higher but then the cables crimp
[bed_mesh]
speed: 120
horizontal_move_z: 15
mesh_min: 14, 0
mesh_max: 214, 200
probe_count: 5, 4
fade_start: 1
fade_end: 14
mesh_pps: 0, 0
algorithm: bicubic
[screws_tilt_adjust]
screw1: 0,50
screw1_name: front left screw
screw2: 250,50
screw2_name: front right screw
screw3: 250,290
screw3_name: rear right screw
screw4: 0,290
screw4_name: rear left screw
speed: 50
horizontal_move_z: 20
screw_thread: CW-M3
[bed_screws]
screw1: 0,50
screw1_name: front left screw
screw2: 250,50
screw2_name: front right screw
screw3: 250,290
screw3_name: rear right screw
screw4: 0,290
screw4_name: rear left screw
speed: 50
horizontal_move_z: 20