1 / 4
Lionel Ready To Play (RTP) 18650 Lithium-Ion battery pack — zdjęcie 1
1 / 4

Lionel Ready To Play (RTP) 18650 Lithium-Ion battery pack

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a battery pack for the Lionel Ready To Play (RTP) 6 C-cell battery powered train that converts it to Lithium Ion

Ocena
0 / 5
Polubienia
2
Pobrania
23
Wydruki
0
Wyświetlenia
259
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

This is designed to work with the Lionel Ready To Play (RTP) trains powered by 6 C-cell batteries. Because the nominal voltage of 6 serial batteries is 9v, which reduces to 6v when discharged. However, we can improve performance, reliability, and longevity using a pair of 18650 rechargeable Li-Ion batteries in series, providing 8.4v at peak charge, but only discharging to 6.4v when fully discharged, and more amperage to spare over the life of a single charge.  

In order to put the two batteries in series with the replacement pack, add a 27mm x 12mm AA battery spring plate to the slot on the closed end of the pack. There's a little ledge there to keep the spring plate from sliding out, but it can be easily added and removed. The model I designed the pack around is the MECCANIXITY AA plate on Amazon, which is 27mm tall, 12mm wide (with a 7mm tab that does not need to be removed), and .3mm thick, but most 2 spring post contact plates with <9mm wide springs should work fine, even if you need to trim a bit. Remember, the bottom 18650 battery has negative facing the Lionel RTP contact spring, and the top battery is positive facing the contact, or the train will not turn on.

I printed this on the Prusa Mini+ and Prusa XL (both using Input Shaper Beta firmware) in black PolyMaker PLA with no supports, standard infill, and part fan set to 25-75% with only overhangs at 100%. Orientation is already correct and no brim should be needed.

This part was designed in TinkerCAD.
 

Tagi