BentoBox v2.0 Carbon filter base for Qidi X-Plus 3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are some modified files of the BentoBox v2.0 Carbon filter to so that it can fit into the Qidi X-Plus 3 printer.
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 148
- Wydruki
- 3
- Wyświetlenia
- 2127
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Files included in this are modfied version of the base and hepa filter to allow for better placement in the Qidi X-Plus 3. Due to lack of room the filter needs to be at an angle and also drop down below the shelf on the rear housing. I've included flange to allow for attaching the filter base to the self on the rear of the housing. I drilled both the flange and the housing but you could also use double sided tape if you didn't want to drill.
On my unit I needed to relocate one of the sensors because the wire was too short and it was in the way.
I did find an unused aux fan socket on the main board that I'm using to power the fan. This is an always on socket so you may want to find a different way of powering the fan.
All the remaining parts were printed directly from the original files.
BentoBox v2.0 Carbon filter for Bambu Lab X1C, enclosed P1P & Voron Trident & others