1 / 5
Enclosure for Adafruit 4ch QT Mux 5664 PCA9546 — zdjęcie 1
1 / 5

Enclosure for Adafruit 4ch QT Mux 5664 PCA9546

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Enclosure with lid for Adafruit 4ch QT Mux 5664 PCA9546

Ocena
0 / 5
Polubienia
1
Pobrania
39
Wydruki
0
Wyświetlenia
205
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is my 4th model in Fusion 360, my 2nd enclosure and my first publicly available model.   I made a handful of iterations on the primary case and a couple on the lid.  Took me about 5 hours with the iterating and testing my design.   Its a similar design to my OpenSensor.io Growmax case (my pet project, a custom PCB that I built) but this is for a much smaller electronic.

Enclosure with lid for Adafruit 4ch QT Mux 5664 PCA9546 – this is for a 4 channel I2C multiplexer board.

Lid slides into place.   Since its a very small part, it is easy to print and doesn't take much time.

About 20 minutes for the primary case and 8 more for the lid with a .15 MM quality setting on a Prusa MK4.

Print supports everywhere for the case – but for the lid I would avoid using supports.

4mm M2 screws are ideal, in my prototyping I only have 5mm available (ordered some 3 and 4's) and you can see the 5mm screws are starting to push out the bottom of the print, so definitely no longer than 4mm.

 

Tagi