SCX24 C10 Rear Bumper

This is a higher-clearance bumper for the SCX24 C10. It honestly primarily looks cool, but also adds a rear hitch option to go with the 3d printed trailer I made: https://www.thingiverse.com/thing:4806919

I designed it based on similar aftermarket designs for real-life Toyota Tacomas.

Thisdoes require trimming the rear of the body for clearance.

Intended to be a bit of a body lift as well, to match my front bumper + body lift post mounts. If you don't want that, you could edit the body mount STL to be a bit shorter.

Required:
Bumper, Bumper frame mount

Optional:
D-rings, hitch receiver, bed plate

Attaches together with M1.6 screws, should be enough left from removing the factory bumper to install, including hitch.

Towing trailer also requires M1.4x12mm screw. (Planning to redesign this.)

Bed plate is optional but supports the body better so it doesn't put stress on the thin plastic around the 2 screws to the back. Remove the rollbar washers and reinstall the rollbar with the screws going through this instead. Planning to redesign the bed plate to cut down on weight.

Update: Just added a refined bed plate that is much smaller, as well as a two-piece bumper so it prints more cleanly. Also cut the bumper near the wheel well to better clear c10 tires, particularly now that I'm running scramblers.

Print Settings

Printer Brand:

Prusa

Printer:

No

Supports:

200

Infill:

AmazonBasics PETG

Notes:

Category: R/C Vehicles