1 / 2
CR-10S Titan Aero Fan Holder — zdjęcie 1
1 / 2

CR-10S Titan Aero Fan Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of CNC Kitchens part cooling fan holder of his Titan Aero mount for the CR-10 which mounts to the…

Ocena
0 / 5
Polubienia
4
Pobrania
78
Wydruki
0
Wyświetlenia
1273
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a remix of CNC Kitchens part cooling fan holder of his Titan Aero mount for the CR-10 which mounts to the stepper motor. I wanted to use a full size NEMA17 (in my case the LDO model used on Prusa machines). So I had to extend the mount and I added some stand offs which go into the holes on the extruder vacated by the screws. I'm running a CR-10S with a Titan Aero and Volcano heater block and my final configuration consisted of the following parts.

  • Titan Aero CR-10 Mount by CNC Kitchen
  • Titan Aero CR-10 Volcano Fan Shroud by CNC Kitchen
  • Volcano Z Endstop Spacer by CNC Kitchen
  • Remixed fan mount from this Thing
  • PTFE holder from this Thing
  • Cable holder from this Thing
    I removed two M3x30mm screws from my LDO NEMA17 stepper and replaced them with M3x35mm screws. I also needed to replace one of the Aero screws with a M3x35mm screw.

    The PTFE holder is designed to take hot press metal inserts which can be installed with a soldering iron, after which M3x10mm screws can be fed in through the cable holder from the bottom.

    I am using a Festo PTFE coupler with an M5 thread and tapped the hole on the PTFE holder. A short length of PTFE can be feed in from the back to guide filament all the way to the coupler. The cable holder takes 2x1mm zip ties.

Print instructions

Licence: Creative Commons - Attribution - Share Alike Category: 3D Printer Accessories Print Settings

Printer Brand: Prusa

Printer: I3 MK3S

Rafts: No

Supports: Yes

Resolution: 0.2mm

Notes:

All parts for my setup were printed in Fillamentum ASA at 0.2mm. I used supports on the fan holder, the PTFE holder and cable holder were printed standing on the bed to avoid supports.

Tagi