Fiddley Diddley

Fidget clicker with embedded magnets. Two models, small and keychain

Instructions

• use three 6x3mm magnets
• pause the print one layer before it starts to close the holes
• watch out for magnet polarity, they need to attract each other
• the button is the same for both small and keychain model
• the button just clicks into the body of the fidget clicker
• i print the body and the button separately because it's easier to insert the magnets correctly and the layer for inserting the magnets isn't the same for the body and the button

That's it, pretty simple. Go annoy people around you.

Oh yeah and if you want, there is a Magnet Pen on my profile if you want it for inserting the magnets.