Slot Bracket for Gotek board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A PC slot bracket that holds a Gotek board.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 321
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a PC slot bracket that holds a Gotek floppy drive emulator in place at the back of a PC case.
Bill of Materials
- This print, of course
- Gotek board
- 3x Self-tapping screws for plastic, lens head, 3.0 x 8
Printing and Assembly
I used PLA, and printed with a resolution of 0.2mm, without rafts and without supports. For better stability, I recommend to use 100% infill.
The LED must be bent into the new position. Take care not to short-circuit the legs of the LED! If you don't need the LED, there is an alternative version without LED hole available too.
There is no space for the 7-segment display, as it doesn't make much sense on the back of a PC. It's better to find a way to mount the display (or an OLED display) to the PC front.