Arducam B0205 IR Case + GoPro Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Quick model of a case with built in go-pro mounting system for Arducam B0205
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 299
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Designed for Arducam B0205
Printed without supports with the flat edge facing downwards. All parts are tolerances by 0.25mm and fit together nicely
I originally designed the case to snap together with pegs that go through the Arducam PCB's mounting holes, but the required diameter of 1.8mm was too fine of a detail to print on my FDM printer. I recommend using a dab of CA glue around the outside edge to join the two halves together.
I recommend shortening the leads of the LEDs for a more clean look - the lens will need to be dismounted to put the front of the case, but will retain all focus adjustments on the outside of the case.
There's a couple of versions available in this project:
Top with/without GoPro Mount
Bottom with/without vents for heat release
Bottom with screw holes for more secure attachment (not tested) - screws will need to be self-tapping screws with a diameter of 1.9mm