LCD Cover and HyperPixel 4 Combo - No Pressure on screen
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This one pose no risk to your Hyperpixel. No pressure on screen, no sliding.
- Ocena
- 5 / 5
- Polubienia
- 46
- Pobrania
- 149
- Wydruki
- 2
- Wyświetlenia
- 2227
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix from this design
https://www.thingiverse.com/thing:3863115
For Hyperpixel 4 on Raspberry Pi 3 (I use a 3B+)
The original design required the printer to be on a concrete slab because the LCD cover was hanging over the edge. This remix lays on the ground. I did not modified the original backplate, but I am including it so you have all the files in one place. The back plate requires 4 m3 screws (11 to 13 cm will fit nicely)
3mf included for easy printing.
You can ignore the warning that says that the toolpath is outside the print area. Tested on my mk3s and it fits.
If you prefer to do it yourself :
Z rotation: 322.5
Fill angle: 10
Bridging angle: 280
Optional: Add a box modifier over the X (kill switch) and adjust infill bridging angle (already included in the 3mf).
To rotate the screen image, add the following lines to your config.txt file:
dtoverlay=hyperpixel4,touchscreen-swapped-x-y=0,touchscreen-inverted-x=0
display_lcd_rotate=3