BIFRC spot welder snap fit case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a snapfit case for the BIFRC spot welder. No mouting screws are required. The case is a tight fit, without…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 156
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a snapfit case for the BIFRC spot welder. No mouting screws are required. The case is a tight fit, without visible gap between the case and the lid.
I used a bit of hotglue to cover the hole for the LED. The light from the LED will lightup through the semi transparant hotglue (if you don't use to much ;) )
The pcb doesn't rattle inside the case and is kept tighly in its position.
Print Settings
Printer Brand:
Ultimaker
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
25%
Filament: Colorfabb PLA black and red
Notes:
I used Cura for slicing. Printed with tree support, 0.1mm layer and 25% infill.
Category: Electronics