1 / 1
Snowpeople or Snowman or Snow_whateveryouwantittobe hanging  or table ornament. — zdjęcie 1

Snowpeople or Snowman or Snow_whateveryouwantittobe hanging or table ornament.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

5.25 inch, 133 mm, or 1.3335e+9 Angstrom SnowPerson. No supports reguired.

Ocena
5 / 5
Polubienia
8
Pobrania
32
Wydruki
0
Wyświetlenia
236
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

5% or more infill. Guessing you could go to none but I haven't tried it. The arms and carrots print in stacks of 4 on a little base and then you clip them off. The reason for multiples is to allow some personalization. The buttons and eyes are all raw 1.75mm filament shoved into the holes and clipped off. Borrowing from Mr. and Mrs. Potato the idea of personalization. I print in PLA on my Aquila (Ender clone - sort of) with the stock settings for PLA.

Each of the 4 arms and 4 carrots on the plate is a bit different. One of the carrots is the rarish dual tip carrot.

I use NO Supports, Raft, or Brim!

I use about 77 grams of filament for the main body with a 3 layer shell and 5% infill.

 

Tagi