WLED Desk Tower Light
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fully 3D Printable RGB Tower Light, 40 cm high, using WLED controller.
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 1039
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Inspired on multiple design arround, but designed from scratch.
UPDATE:
- Cover V2.stl has some more clearance around the tower
2 USB C connectors are used to daisy chain another light, .since it 1 light at max power only draws 1.5A a 3A power brick can be used to power 2 lights.
Electronic parts needed:
- Wemos d1 mini (or other wled compatible controller)
- USB C adapter boards (2x)
- WS2812B LED strip (24leds) (10mm wide)
- USB C Power brick
Connecting is fairly easy connect the 5V from USB C boards, Wemos and LED Strip and do the same for the GND.
Make sure the data wire from Wemos (defaults to D4) is as short as possible otherwise a level convertor will be needed.
Use some glue to connect the top tower to the base.
Be carefull mounting the diffusors since they are pretty thin, it is a little bit fragille, but making them thicker is going to block to much light.
I used PLA, no supports are needed.
Inspiration source:
https://www.printables.com/model/189123-rgb-light-tower
WLED info: