Deburring and cleanup tool for outside edge of round parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A sanding tool to help clean up the brim and first layer squish of small round parts
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 653
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Printing small parts using a brim or when the printer spreads out the surface against the built plate leaves edges that are very hard to clean up. A small file or sandpaper on a flat board can be used. Although a deburring tool is handy for cleaning up inside and long straight edges, they don't work well for the outside circumference of small round parts.
This handheld tool is conical which makes it easier to deal with those outside edges.
The cone holds a piece of sandpaper, cut to match the cone, and the screw on top holds it in place firmly for when you sand your parts. Diameters up to about 50mm can be deburred.
Debris falls down into the hollow handle to be discarded when done.
The sandpaper cone is shown as a pdf file which should print to the correct shape if printed 1:1. The dimensions (small radius 12mm, large radius 42.4mm, angle 105°) are shown in the drawing, I find it easier to just draw it on the back of the sandpaper and cut it out.
Stick the cone ends together with adhesive tape, insert the conical form then screw the ring onto the handle/cone part, the 2 parts clamp the sandpaper cone to the surface.
I use between 80 and 180 grit sandpaper depending on the part I'm working on.
If you have really small parts you can reduce the diameter of the smaller circular cutout so that the hole in the tip of the cone is smaller, it won't be supported as solidly but the small diameter will make it reasonably rigid for sanding plastic parts