Connecting Towers, Walls, and Wizard Tower for Castle Panic
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix: Interlocking pieces prevents them from being knocked around
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 146
- Wydruki
- 0
- Wyświetlenia
- 989
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Share Alike
With my son over for Thanksgiving, we pulled out Castle Panic, one of the games we used to play a lot when he was a kid. We had a blast but Tawnos76's great towers and walls kept getting knocked around.
I ended up remixing the parts by adding connectors to the walls and towers, to hold the pieces in place. While doing this, I also discovered CHalts' excellent remix of the towers, so I swapped those in for Tawnos76's original pieces.
You'll need to print 3 male and 3 female walls and towers. Or 3 female and 2 male towers, if you plan on using the wizard tower. I was considering single components with both a male and a female connector but I feel the separate males and females are easier to connect and disconnect.
No special print instructions. I used a 0.4 mm nozzle and 0.2mm layer height, 5% infill. Make sure you have a perfect first layer, or the towers make shake loose.
If you like what I'm doing…
… consider buying me a coffee or joining my Club.