Tall Teabag Dispenser with easy-load slot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a taller teabag dispenser without a display window for MAXIMUM TEABAG
- Ocena
- 0 / 5
- Polubienia
- 42
- Pobrania
- 324
- Wydruki
- 2
- Wyświetlenia
- 1231
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Put yer individually wrapped teabags in here.
A variety of heights available:
- 240mm → holds around 64 teabags
- 120mm → holds around 32 teabags
This is not strictly a remix, since the model is made from scratch and has a lot of changes, but @xavierly had some design choices I really liked and took inspiration from:
- Space under the lowest teabag for easier grabbing
- Slant of the teabags for easier grabbing
- Able to print without supports (really strange how most other teabag models seem to ignore that QOL improvement…)
However, I have made a few changes in the design to suit myself:
- Loading the teabags is easier with a slot that goes all the way up in the front
- Gotta have a tallboi
- I don't need a lid
- I don't need a ‘display slot’
There are ‘thin (0.8mm)', and ‘THICC (1.6mm)’ versions for each height.
You can probably get away with the thin one if you have 0.4 nozzle, since it is exactly 2 walls.
However, I use a 0.8 nozzle, so it was a cleaner and stronger print to go with the 1.6mm walls (pictured).
Print is around 5 hours with my 0.8 nozzle and 0.32 layer height on an Ender3 S1.