Fractal Design Terra Upside-Down mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount to attach your Fractal Design Terra under your desk
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 76
- Wydruki
- 0
- Wyświetlenia
- 1791
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
Holds your PC upside down under your desk so it doesn't take floor space or dust.
It's meant to be screwed in using the 4 middle fan holes.
Uses:
- 4 M5x20mm bolts,
- 4 4x45mm wood screw (assuming you want to go 30mm into your desk),
- 4 M5 2020 extrusion sliding nuts or regular M5 hex nuts
Fits any GPU width configuration. The screw under the GPU can be hard to put in and screw as it's blocked by the GPU bracket.
There's a 3mm hole on the side to lock the PC from sliding, you can put an allen key in there or a long M3 bolt (length>35mm). You're meant to slide the PC towards you when putting it in.
Tolerances are 0.2mm.
Doesn't need any supports, about 6hrs to print.
PS : Don't print this in PLA, otherwise it'll warp from the heat of the PC in about 2 weeks.