mini nuke snoball mold
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mold made to shape snow into a snowball that looks like a mini-nuke, it prints in place with no supports.
- Ocena
- 4,733 / 5
- Polubienia
- 382
- Pobrania
- 1241
- Wydruki
- 17
- Wyświetlenia
- 4570
- Oceny
- 15
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Share Alike
This is a mold for snowballs to make it look like a nuke. It is a quick and easy print-in-place print at 1 hour and 45 minutes on Bambu labs p1s with no supports.
print settings/info
filament: 45ish grams when printed with 3 walls and 15% infill
supports: no
layer level: .2mm
brim: no unless you like using them or have bad bed adhesion
speed: however fast your printer can handle. but…..
….I would slow down bridges and steep angles. for the Bambu labs/orca, slicer turn on “Overhang Speed ” and set bridges and 75-100%angles to 30mm a second or slower. And for Cura, turn settings to All then go to the experimental section and set the overhanging wall angle to 70 degrees and the overhanging wall speed to something like 10%.
while that looks complicated it's easy and makes prints look much better but if you don't do it they will still function fine
have fun printing and ruin someone's day for me by throwing one down the back of thier jacket!!
any feedback would be welcome.