1 / 4
Caribou3D-style Bondtech Extruder Carriage for Prusa MK3s/+ — zdjęcie 1
1 / 4

Caribou3D-style Bondtech Extruder Carriage for Prusa MK3s/+

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remeshed Bondtech Extruder Carriage from Caribou3D to suit the original Prusa MK3s/+.

Ocena
0 / 5
Polubienia
8
Pobrania
131
Wydruki
0
Wyświetlenia
1424
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is the Bondtech extruder carriage from Caribou3D for Prusa MK3s/+. This would allowed you to replace the existing designed without adjusting the firmware. To me, this multiple pieces x-carrage is eaiser to be installed and helpful for the maintenance as well.

The existing Caribou3D x-carriage is slightly wider. The x-axis calibration will be failed if you do not adjust the firmware.

This remeshed x-carriage had been tested for few months. 100% working well.

Take note of that the bearing holders are designed based on MISUMI Linear Bearing LMU8.

Tagi