LM2596 Enclosure - Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of a simple enclosure for a LM2596 buck converter with tabs on the outside and screws on the top.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 102
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I added tabs on the outside to screw the enclosure down. This allows the enclosure to be moved with out removing the buck converter. The tabs can be snapped if you do not need them at some later point. Alternatively I provided a version of the part without the tabs to print directly.
Additionally you can screw down the lid of the enclosure with two short M3 screws.
ATTENTION: I had some problems with the alignment of the holes for the LM2596. Only one screw fitted for more. I was still able to use the print though.
This design is part of my frame, bracket and holder collection for various boards and components: https://www.printables.com/@a123qwertz567/collections/2632544
Print instructions:
- recommended layer height 0,2 mm
- No supports needed
I would be happy to see some of your makes posted :)
Source files in the Alibre Atom format is available but the website does not allow the upload. If you need it send me a message.