Shield / Sword Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shield / Sword Holder (large). Guess it could be used as coat rack if so desired. (Tepig not included)
- Ocena
- 0 / 5
- Polubienia
- 28
- Pobrania
- 160
- Wydruki
- 0
- Wyświetlenia
- 909
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial
Needed a sword holder for my son's room, so I whipped up this model. Tepig is NOT on the downloadable version (if someone wants that, message me and we can work it out).
It is a large print that I did in 1 piece on my Neptune 4 Max. The picture with the 3 samples are printed at 35% scale so it can be made smaller depending on what you will use it to hold. The one sample picture shows both versions with my tests at layer change/colors and the one graphite (partially) rubbed.
2 Versions are available:
Shield_Single - Is the one pictured with the swords. It has a flat back and ‘hooks’ on the front to place the swords (or coats) on. I printed it with 5 perimeter walls to beef up the hooks, 0.20mm layer height, and 10% gyroid infill, no supports needed.
Shield_Bottom & Shield_Top - I did not print a full-size version of this as we went with the “Single” model for our son, however there is a 35% version shown in the one sample pic. These both can also be printed with 5 perimeter walls, 10% gyroid, no supports needed. This one needs glueing together, and you would need to slide the swords down inside after mounting to the wall. Probably not suitable for coats :)