Christmas Light Over a LED BR30 Light
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
LED BR30 bulb to...... CHRISTMAS light!
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 205
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Noncommercial
Reason:
Enhance some existing lights with some 3D printed slide over Christmas bulbs. A boring old canned LED BR30 light just sitting there…
Cover it with a slide over Christmas bulb for some festive ambiance…
USE ONLY ON BR30 LED BULBS AND EVEN THOUGH MAKE SURE THEY ARE NOT HOT!
I have Phillips WIZ BR30 light changing bulbs.
Printing and Installation:
Print on vase mode(.25mm layer height) in the PrusaSlicer… I have tried both PETG and PLA and both appear to work.
Then using scissors, cut 4 cuts approximately as shown in the picture approximately 90 degrees apart. The depth of this cut may vary depending on which manufacture LED BR30 you are trying to cover AND WHAT FILAMENT YOU ARE USING. PETG will need less. Start small and work into it. The cuts allow it to flex around the BR30 LED bulb easily. The undercut then keeps it from falling off.
Install by sliding on a slight angle as shown. If it is to hard flex the cut strips or perhaps snip a little bit more with the scissors.
Remove them by reversing the process.
I have also attached one that can print on the MK3s+ and MK4. Also linked is the Onshape docs if anybody wants to do some remixes to them.
XL Onshape doc
https://cad.onshape.com/documents/e7b79592428a90c0f0e8570d/w/5a6a077eaa07f2147f5771e1/e/fbf75412aa1a9e2eeb99d87b
MK3s+ MK4 Onshape doc
https://cad.onshape.com/documents/5c5d1bbeae5028485175a36c/w/3f62ca8fa89d765b1fa8e294/e/d8d4da18faf9fcb1221cc750