Gridfinity JerryRigEverything Razor Utility Knife, Blades, and Accessory Block

A 3x1 Gridfinity block to hold the JerryRigEverything Razor Knife, the small plastic capsule with spare blades, and any accessories in the optional accessory slot. The knife should rest perfectly in only one orientation, ready to grab. The spare blade slot is large enough to fit the protective capsule with spare utility knife blades. 

The multipurpose accessory slot is a 14.5mm x 24mm rectangle with a center ⌀17mm circle, all cut 20mm deep. This can fit the capsule of spare blades vertically, lip balm, small flashlight, small multitools, etc. Files are included with and without this section. 

Print as you would any Gridfinity pieces. The print in the pictures specifically was done via PrusaSlicer on a Prusa MK4 w/ input shaping @ 0.20mm SPEED layer settings, 10% infill, with a 0.4mm nozzle. No supports used or needed. 

NOTE: The translucent/polycarbonate scales of the “Clear” version of the knife are apparently thicker than the rest of the colors, and may not fit this knife holder model. STEP files are included if remixes are desired. Thanks @Nathankenned_1607894 for the heads up.