1 / 1
WLToys 124007 / 124017 RC Car – chassis side wall extensions (FreeCAD)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
get higher side walls, close the gap to the body shell
- Ocena
- 0 / 5
- Polubienia
- 32
- Pobrania
- 299
- Wydruki
- 0
- Wyświetlenia
- 1709
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (33)Powiązane
After driving through fresh snow I found the car full of snow… there was a huge gap between chassis and body shell. This model closes these gaps.

Printing
PLA+, snug support, see 3mf file attached, Any other material may work, too.

Assembly
The three pegs fit inside the plastic sides of the car model. Use three M3×18 bolts per side to attach the extensions.