Cam Holder for Elegoo Neptune 4 Pro (Logitech C270)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Camera holder for Elegoo Neptune 4 Pro (not for the Non-Pro) for older versions of Logitech C270 Webcam.
- Ocena
- 3 / 5
- Polubienia
- 24
- Pobrania
- 252
- Wydruki
- 2
- Wyświetlenia
- 1966
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
The camera holder for Logitech C270 webcam is attached to the X-end stop cover with the screws on the left and bottom side (see picture). The existing screws are long enough.
The mount consists of two parts (bracket and camera mount) that are plugged together. They usually hold together through friction, but can also be glued together.
The camera can be separated from the original mount by loosening the small screw at the end of the axis and pushing out the axis. Before printing the holder, check if the axis looks like that shown on the picture, there are obviously different versions of the cam. If necessary, rework the hole in the newly printed holder with a 3.2mm drill after printing and connect it to the camera by pushing in the axis.
In order to be able to adjust the image sharpness, I recommend this camera modification:
https://www.printables.com/de/model/279970-logitech-c270-focus-ring
The bracket requires support, the camera mount can be printed without support.
Edit: Upon request I added a shorter holder (Cam_holder_holder32), that moves the cam position one cm up.
Updated Oct. 28, 2024
-------
Der Kamerahalter für die Logitech C270 Webcam wird an der Abdeckung des X-Endstopps mit den Schrauben auf der linken und unteren Seite befestigt (siehe Bild). Die vorhandenen Schrauben sind lang genug.
Die Halterung besteht aus zwei Teilen (Winkel und Kamerahalterung), die zusammengesteckt werden. Sie halten meist durch Reibung zusammen, können aber auch miteinander verklebt sein.
Die Kamera kann durch Lösen der kleinen Schraube und Herausdrücken der Achse von der ursprünglichen Halterung getrennt werden. Vor dem Drucken des Halters bitte überprüfen, ob die Achse wie auf dem Foto aussieht, es gibt offenbar verschiedene Versionen der Kamera. Die Bohrung in der neu gedruckten Halterung nach dem Druck ggf. mit einem 3,2mm Bohrer nacharbeiten und mit der Kamera durch Hereindrücken der Achse verbinden.
Um die Bildschärfe einstellen zu können, empfehle ich diese Modifikation der Kamera:
https://www.printables.com/de/model/279970-logitech-c270-focus-ring
Der Winkel benötigt support, die Kamerahalterung ist ohne Support druckbar.
Edit: Auf Nachfrage habe ich einen kürzeren Halter (Cam_holder_holder32) hinzugefügt, der die Kameraposition um 1 cm anhebt.
Aktualisiert 28.10.2024