Tablet stand/holder with side grips
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remixed tablet holder that encases the bottom of your tablet/iPad and has grips on the side for easier carrying.
- Ocena
- 0 / 5
- Polubienia
- 37
- Pobrania
- 424
- Wydruki
- 0
- Wyświetlenia
- 1837
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
I remixed the original to meet my own specific needs.
The design changes prevent the tablet from sliding out the side of the holder or rocking off the side if not centered correctly. It also makes it easier the carry the tablet and stand together with only one hand due to the “grips” that have been added on the sides.
Sizing Instructions
This was designed to fit my 11.5 inch Lenovo tablet, so it's pretty large to start off.
The length of the inside of the tablet holder is 274mm.
Scale the model accordingly to match the length of your own tablet/iPad, plus 1-2mm extra to ensure it's not too small. Make sure to measure your tablet with the cover on if you use one.
I'd suggest only scaling it on the x-axis so that only the length is changed. If you scale down the y and z axis too much it may become too short to support your tablet or too narrow for it to fit in the slot.
No supports required, it comes out nicely with a 0.2mm layer height and 10% infill. Definitely use a brim to prevent warping.