Multipurpose telescopic hanger with clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Telescopic hanger with detachable clamp - clamp surfaces up to 44mm
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 370
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Here's a telescopic hanger I made to hang my headphones off the edge of my desk or off the leg of the desk - can be used in either orientation.
All parts print without support (there is a support designed into the file for the cleat overhang on the clamp) and the telescopic part prints in place (it may need a little convincing to lift off the bottom initially).
Worth adding a small piece of thin rubber or non-slip material to the plate and opposite side on the clamp to help with grip (particularly when clamping to a vertical support).
Diameter of the rail is 30mm.
- Infill: 15%
- Supports: No
- Layer Height: Variable (recommended) or 0.2
- Walls: 5 (recommended for strength)
Second picture shows printing orientation. I printed in PLA, but PETG or similar may be better for the clamp.
Clamp shown in photos was my prototype. The uploaded file has a thicker spine to prevent bowing when under tighter clamping pressure.
I may design further attachments for the clamp and update this page accordingly.