Ceramic Christmas Tree Bulb Replacements (Vase Mode)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One-piece design that prints quickly.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 154
- Wydruki
- 2
- Wyświetlenia
- 1025
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution
A friend of mine was missing some of the inserts for her ceramic Christmas tree, so I went looking here and found something that was close to what I wanted. A few tweaks produced this.
Print in vase mode with 2 bottom layers, 0.2 mm layer height, 0.6 mm extrusion width, and a 5-mm brim. Transparent PETG would most likely provide the best results. If you place the models far enough apart on the build plate, you can also print them in batches for greater efficiency. (I did 9 at a time, but might have been able to do 12 to 16 at a time if I tightened up the spacing a bit.)