1 / 5
FPV TPU Cam Mount - AKK AIO-SA / TheFPV SA Micro AIO FPV Camera and 200mW VTX — zdjęcie 1
1 / 5

FPV TPU Cam Mount - AKK AIO-SA / TheFPV SA Micro AIO FPV Camera and 200mW VTX

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A TPU FPV Camera Magnetic Mount for the AKK AIO-SA / TheFPV SA Micro AIO FPV Camera and 200mW VTX.

Ocena
5 / 5
Polubienia
13
Pobrania
89
Wydruki
1
Wyświetlenia
698
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Share Alike

So I wanted to make an FPV Camera mount for the AKK AIO-SA / TheFPV SA Micro AIO FPV Camera and 200mW VTX.
I though this could be fun to mount on to a RC Car and then use the camera with any 5.8ghz Analog Monitor or FPV Goggles.

FTX Outback Mini 3.0 Ranger 1:24 RTR Green is the RC Vehicle shown in the image.
(Official site) (Unmanned Tech Store UK)
 
Had some fun driving this for a bit!


Depending on usage please watch out as it could overheat!


I was using PLA at first to get measurements and then I designed an all in one piece since I am new to TPU.
You just print, slip it in and slide the cables through carefully.
A slot to slot in a magnet within 10mm dia x 1.5mm. (Amazon UK Magnets)
A second magnet I put under the shell of the RC Vehicle.

WARNING: This camera doesn't support PH2 out of the box,.
You will need to make an adapter.
I believe it uses SH1.0 or MX1.25 and I converted it to JST-PH 2.0 or and adapter to Molex 51005 51006 2.0mm pitch
I made an adapter cable to use a battery with a PH2 connector for the camera.

If you find use of this please post a make! I would love to see.



Print settings.

Printed with Overture Black TPU with 40% Infill and 0.2mm Layer height.
Creality Ender 3 Neo with Stock bed and Tungsten Nozzle.

Tagi