1 / 4
Sovol SV06 Spool Side Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Its a Side Sppolholder Mount for the Sovol SV06
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 926
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (1)Kolekcje (29)Powiązane
What is it and why you may need it.
It is a Side Spoolholder for the Sovol SV06. I created it because I didn't have room above the printer to mount the Spoolholder. It is at a slight angle so the Filament would feed smoothly in the Extruder without any hiccup.
Print Settings:
- Orientation: I recommend printing it in the orientation that I uploaded it.
- Infill: 25% and above
- Support: No Support needed because the screw holes for mounting it to the printer have a sacrificial layer which just need to be either drilled out or with a screw and a bit of force pushed through.
How to Assemble:
Just Screw the Filament Holder in to the 3D Print with the to Original M5*10mm Screws. Like seen in the Picture below.
Then you Add in The other Two holes 2 M3*12mm screws and 2 T-Slot Nuts. Then Just Screw it to the aluminum extrusion.