1 / 6
Anti vibration feet MK4 MK3/3S/3S+ low profile — zdjęcie 1
1 / 6

Anti vibration feet MK4 MK3/3S/3S+ low profile

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Antivibration feet for prusa mk4 mk3/3S/3S+ with small elevarion of the printer. Compatible with PrusaOriginal Enclosure

Ocena
4,8 / 5
Polubienia
47
Pobrania
393
Wydruki
6
Wyświetlenia
1443
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Antivibration feet for prusa mk4 mk3/3S/3S+ with small elevarion of the printer.
Compatible with PrusaOriginal Enclosure.

Compatible with 3030 aluminium extrussions.  A little wider to accommodate the console cables.

Tested on Prusa MK3, MK3S, MK3S+ and MK4 on the table AND in the Original Enclosure from Prusa. With the enclosure it reduces a lot vibrations and noise created by the enclosure.

It allows movements in three directions, allowing vibrations to be isolated and significantly reducing the noise generated.

In my setup, furthermore, the Prusa Original Enclosure is supported on supports with squash balls.  There are many designs on Printables. Using both, I can print even at night.

USE

I use 6  pieces placed 2 near the vertical frame, 2 at the fron and 2 at the back. Avoid excessive deformation of the cables. It doesn't have to be at the extremes.

When in the Original Enclosure avoid the rubber bumpers. It works well even if it is not in the ideal position.

PRINTING

The STEP file is solid. The idea is to make it hollow when slicing it.

Tested configuration:

  • Material PETG (better flexibility and isolation).
  • Layer height: 0.3 mm.
  • Nozzle 0.4 mm.
  • extrusion width 0.6 mm.
  • 5 perimeters. Depending on flexibility required and filament material you can try from 3 to 6 perimeters.
  • No infill, no top layers, no bottom layers.  Random seam.

You can change the number of perimeters to big changes in rigidity and change the extrusion width from 0.4 mm up to 0.6 mm to increale slightly rigidity.


Changes

MK4

  • Following @Brubba_1369635 comment, I reduced width to avoid colidin with motherboard box in MK4. 
  • As I've the mk4 inside the prusa enclosure, I've the power supply outside the enclosure, so no interference found there. Any information about interferences with the power supply is welcome.
  • Change in number of perimeters recommended. 6 perimeters seems a good starting point for MK4 as it moves really fast.

MK3*

  • As the accelerations are much lower than in the MK4, possibly 5 perimeters is enough. As always, it depends on the filament you use.


 

Tagi