Sonos Arc with Samsung QE55QN90B TV riser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A riser with cable channel that goes under a Samsung QE55QN90B TV base so it sits just above a Sonos Arc soundbar
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 645
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
The base on the Samsung QE55QN90B is not very high, so you can't use it with a Sonos Arc soundbar as the TV screen would sit below the height of the soundbar.
This simple Tinkercad design riser goes underneath the TV base to raise it up so the TV screen sits just above the height of the soundbar so you can see it.
The riser also has a cable channel to help hide the cables running from the Sonos Arc so they come out at the back of the TV under the base.
| File name | Description |
| Samsung QE55QN90B riser.3mf | The full model if you have a large enough print bed. |
| Samsung QE55QN90B riser - dowels.3mf | For mid-sized print beds like the Prusa MK3S+ or Prusa MK4. I used PrusaSlicer slicer to cut the model into two parts with dowel pins to connect them. This is the version I printed on my Prusa MK3S+ at the time. I found the pins were a bit too narrow so I swapped them for some metal pins I had and glued them in place. |
| Samsung QE55QN90B riser - dovetail.3mf | I've not printed this, but it might have a stronger fit than the dowels version. |
Or, just use the full model and cut it up in the slicer yourself :o)
Additional materials:
- 8 of 5x5cm 5mm high non-slip furniture pads (I used these), 4 under each side of the model to protect furniture and stop it from slipping
Print Settings I would use:
- Resolution: (Prusa MK4) 0.20mm SPEED
- Perimeters: 8
- Filament: PETG
- Supports: No
- Brim: No
- Infill: 20%