1 / 2
Anycubic Kobra / Kobra Go / Kobra Neo - Bed Alignment Cover — zdjęcie 1
1 / 2

Anycubic Kobra / Kobra Go / Kobra Neo - Bed Alignment Cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Clip-on bed alignment for Anycubic Kobra / Kobra Go / Kobra Neo

Ocena
3,667 / 5
Polubienia
58
Pobrania
845
Wydruki
5
Wyświetlenia
3649
Oceny
6

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

IMPORTANT: as I don't have an original Kobra, this was not yet tested. If you print it and it works, please post a make and a comment so I know if It works, if I need to improve something or take the model down.

-------

UPDATE: based on feedback, I added a v2 of the part. It can be printed upside down and requires less supports. Also, the left side if moved 2mm more outwards and the hooks are a bit thinner for easier clip in and out.

--------

This is a clip-on cover for the cable connector that goes to the bed of the Kobra, Kobra Neo and the Kobra Go. The cover is meant to act as a bed aligner. It is also easy to put on and remove as it "clicks" into place and stays there quite tightly.

In the 3mf file for Prusa Slicer I also manually added the supports including settings for their (relatively) easy removal. I tried to keep the actual fence of the cover as low as possible while still allowing for easy alignment.

Tagi