Tails - With Spinning Tails
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified body and tails for "Tails - Classic", using ball bearings to make the tails spin. Anatomically correct ;P
- Ocena
- 0 / 5
- Polubienia
- 216
- Pobrania
- 497
- Wydruki
- 1
- Wyświetlenia
- 4838
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This combines the ball bearing spinner from “Sonic The Hedgehog Fidget Spinner” with the character model from “Tails - Classic”. The result is a 100% anatomically correct (wink wink) model with spinning tails.
Printing instructions
Find the full set of original model files at https://www.printables.com/model/642016-tails-classic
- Replace “tail_orange_left” and “tail_orange_right” from with “tails_spinner”.
- Replace “body” with “body_spinner”.
When slicing, be careful with infill settings on the body - the extension up towards the ball bearings holds a lot of weight and should be as strong as possible (I used 15% grid infill and that part was hollow, so it snapped x_x).
- You might even want to reinforce with (metal/wood) dowels since the model may be picked up and handled more than a fully static version.
Assembly instructions
Friction fit between body → ball bearings → tails should be enough, and then the model can stand on its feet + tails. The tails can spin freely if you hold it from the body or head.
I recommend these ball bearings: https://www.amazon.com/dp/B08H4LV1TZ, though these can also work: https://amzn.to/3ul0rg0 .