toilet board distancer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
don't you just hate it when you have to replace the whole wc board 'cause those plastic distancers pop out and get…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 90
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
don't you just hate it when you have to replace the whole wc board 'cause those plastic distancers pop out and get lost, or break up, crumble...
freecad source available, the values are not in separate table but there are 2 sketches in total so really super simple to change size in freecad or just rescale in the slicer to get proper size for your board
I'm printing them 0.3mm layer, some hard tpu from hobbyking (much softer than regular plastic but not nearly as soft as those fully flex filaments like ninjaflex) at 80% gyroid infill and 0.4mm line width 4 perimeters (I use ideamaker that adds additional wall thickness in the 45 degree area so depending on the slicer you might want to add more perimeters)
no supports required (45 degree overhang)
Category: Replacement Parts