Buck Converter Housing LM2596
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For those looking at powering hobby electronics or moding your printer to accept a 12-volt fan to replace a 24-volt…
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 162
- Wydruki
- 1
- Wyświetlenia
- 1594
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
For those looking at powering hobby electronics or moding your printer to accept a 12-volt fan to replace a 24-volt fan ... you're likely going to use a buck converter, and you may well want to place that in housing to make sure you have no shorts (and to make sure that it does not get knocked around).
This housing for the LM2596 type converter features ;
-Top and bottom ventilation
-View of the direction-of-operation indicator
-Access to the potentiometer adjuster
-View of the operation-indication LED
-Access for +/- terminals at each end
-Side latches
See the video below for a mounting demo. Feel free to add screw-down tabs or modify/reshare/distribute however you want. The original BLEND file is attached also (finally I produced a BLEND without embarrassing topography! :D )
Rock On!
Print Settings
Rafts:
No
Supports:
No
Resolution:
Any
Infill:
n/a
Filament:
[
3rd Axis (imported) ABS , purple only, please
Notes:
Test-printed fine
Post-Printing
None required. Prints in two parts with no supports all-at-once
How I Designed This
Designed in Blender.
Category: Electronics