1 / 5
Shoei VFX-EVO Universal Chin Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With provisions for an M6 nut & bolt, this sturdy chin mount can mount a variety of equipment like lights or cameras
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 546
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Required materials/tools:
- Small Phillips screwdriver for helmet disassembly
- Standard M6 nut
- ≥ 10mm M6 bolt
- Safety wire & 3M VHB tape OR epoxy
Printing tips:
- ABS, PA, PA-CF/GF recommended
- Fuzzy skin optional, but it provides better adhesion
- 40% infill
- 5 walls
- Supports on build plate
- IMPORTANT: No supports in safety wire channel
Assembly/mounting tips:
- Clean helmet mounting surface with alcohol before adhering
- Safety wire should be considered mandatory since the connection between the mount and the helmet is not very rigid with VHB tape alone. If using epoxy to permanently adhere the mount to the helmet, safety wire may not be necessary
- The M6 nut on the backside is held in with friction and is expected to be a tight fit. Due to printing or nut sizing variations, you may find it necessary to adhere the nut in it's recess to keep it from falling out
- Ensure the V-groove at the top of the mount rests firmly against the matching surface on the helmet chin piece for maximum stability. Retaining the mount with safety wire will ensure consistent contact in this area