Bulkhead fitting for a 1/2" poly hose
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This lets you make a connection from a 1/2" poly hose to a tank.
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 228
- Wydruki
- 1
- Wyświetlenia
- 734
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This lets you make a connection from a 1/2" poly hose to a tank.
Instructions
You'll need to add a garden hose washer so that it won't leak. Print it with a 100% infill, otherwise the bottom of the connector may break off as you tighten down the nut.
Update - I uploaded a slightly newer version (v05) that makes the area around the washer a little thicker, the hole in the middle a little smaller (so that the walls are thicker), and the nut a little smaller (so it puts less pressure on the threads when you tighten it down). A regular hose washer still fits it but you'll need to push to get it over the last bit of plastic. It is a lot stronger now but you should still only hand tighten (snug but not too tight).
Category: Outdoor & Garden
(Originally posted on Thingiverse in 2015)