Milwaukee M18 tool mounts for workshop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are an easy fit and print with no supports
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 180
- Wydruki
- 0
- Wyświetlenia
- 1492
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I downloaded and printed a version I found elsewhere but it was too tight and would not allow the tool to slide in - not sure what happened there - maybe it was made with tolerance too tight but would have worked in PLA?
Anyway this is my version. Printed in two parts (I used PETG, recycled Prusament for the ugly dark green and Lipstick Red Prusament for the block). No supports are required. The height of the spacer (block part) is sufficient to accommodate the metal belt clip that a lot of tools have. The two parts will slide together and in the vertical direction are very strong once the mounting screws are attached. The screws support the assembly through the centre of gravity of a hanging tool. The hexagonal cuts in the block make a very solid foundation of perimeter rather than infill when printed.