SKR 1.4 turbo case with source files
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This a case I designed for the MPCNC lowrider 2. It has two angle mount that screws into the bottom of the case.…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 710
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This a case I designed for the MPCNC lowrider 2. It has four 1in pipe clamps that screws into the bottom of the case. there are holes for JST and xt60 connecters .You can use the case normally just remove the pipe clamps. source files included.
I have spent countless hours designing this model and would highly appreciate if you left a tip.
fasteners:
(optional) 4 m5 x 20mm for pipe clamps and angle mount,
4 m3 x 10mm
4 m3 x15mm
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
15
Filament:
Overture PETG ](http://www.amazon.com/s?url=search-alias&field-keywords=Overture+PETG&tag=thingiverse09-20) Blue
Notes:
none of the model need supports.
Post-Printing
assembly
1.(optional)Crimp 4 pin and 3pin JST connecters and glue them in place.
2. (optional) If you want to attach the case to the pipe. screw the pipe clamps in with m5 x 20mm screws they will cut there own thread.
2. Use the m3 x 10mm to screw the board into the case.
- connect all the the wire and display now.
5.Use the m3 x 15mm to screw the top onto the main body of the case. - line up the clamps and push down and they should snap on. It does require a lot of force.
You can tighten the clamp with a bolt and not through the clamp. - (or) use the angle mount. line the mount up on the angle and screw it in.
Category: 3D Printer Accessories