Treat dispenser toy / slow feeder for dogs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A rolling treat dispenser for dogs. I wanted a dog toy that challenges them mentally (to some extend), so I designed…
- Ocena
- 5 / 5
- Polubienia
- 71
- Pobrania
- 169
- Wydruki
- 1
- Wyświetlenia
- 1906
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
A rolling treat dispenser for dogs. I wanted a dog toy that challenges them mentally (to some extend), so I designed this toy (with inspiration from the internet).
The roll can also be used without the base. One of my dogs doesn't like to roll the toy, so I put the roll without the base on the ground and he flips the roll to get the treats.
The file ''HoleCap12mm'' is an insert for the holes to make them a little smaller for smaller treats, or to make it a little harder to get the treat.
The only hardware used are: 2x ball bearing(608zz), 2x M4 bolt, 2x M4 threaded inserts
Although the inserts are not necessary, u could also make the holes smaller and just make thread in the plastic instead.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Notes:
I printed everything with PLA, but other materials can also be used (I think ABS can be toxic though). Everything is printed with standard Prusament PLA settings from the PrusaSlicer with 0.2mm layer height, 3 perimeters and other modifications listed below:
Roller_V2
0.15mm layer height for the thread|| Lid_V2
0.15mm Layer height|| Stand_V2 (print 2x)
Supports are needed for the ball bearing hole. I used dynamic layer height to get a better cosmetic result for the back, but this is not necessary.|| Bolt_V2 (print 2x)
I printed this with all perimeters, but in hindsight only 2 perimeters with 100% infill would be better (less chance for layer separation when trying to put the bolt in).|| Base_V2 (print 2x)
No extra print settings|| HoleCap12mm (print 3x)
I printed these of TPU with normal settings. I think this part can also be printed of PLA/PETG but i haven't tried it and don't know if/how it will fit
Post-Printing
Roller_V2 And Lid_V2
In these parts are small holes at the end. These holes are meant for M4 threaded inserts, but they can also be made smaller so that thread can be made directly in the plastic.
Bolt_V2 (x2)
This part needs to get an M4 bolt threaded through. The bolt needs to be threaded in! Do not drill the hole wider!
Stand_V2 (x2)
This part needs the support removed after printing. After removing the supports press a 608zz ball bearing in the hole
Assembly
- Screw Lid_V2 in Roller_V2
- Put the Bolt_V2 (with bolt screwed in) in Stand_V2 from the curved side (x2)
- Screw the M4 bolt (with Bolt_V2) in the threaded insert/threaded plastic in Roll_V2/Lid_V2 (x2)
- Put both parts Base_V2 together
- Insert both Stand_V2 parts in the Base_V2 parts
- (optional) put HoleCap12mm in the holes of Roller_V2 (x3)
All done and ready for use!
Category: Pets