HP Common Slot PSU Breakout Board Support Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Support extension for use with GPU/mining-style breakout boards on HP Common Slot PSUs
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 437
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
This model fits my particular breakout, labeled “ATX64P6-N02 VER003”, very well, but may need tweaking for others if their dimensions aren't the same. All the dimensions are variables in the OpenSCAD file, so it should only be a matter of tweaking them and exporting a new STL.
Note that the version labeled “full access” gives access to all 12 GPU power connectors on the breakout board, while two of them are blocked on the other version by the stabilizer on one side. I personally would go with the “blocked” version for a bit better stability, unless you had a need to be able to use all 12 connectors. Hopefully the photos explain this better than I just did.
Needs one M3 nut and M3 screw (probably at least 10mm - I used 20mm because that's what I had) to clamp it securely to the PSU.