Storage boxes/containers/bins for steel workshop cabinets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Storage boxes with divider tabs primarily used for steel workshop cabinets with drawers. Simple design but sturdy.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
This is my 3 years old model, used and printed primarily for organizing small parts inside steel cabiets' drawers. The walls and bottoms are 2mm thick and are proven for over 3 years with no failures. Easy to print, consumes a a bit more filament if you use more than 2 perimeters but can be printed from any material on virtually any surface.
Compatible with metalfurnitureenprag.com and/or kovovynabytek.cz workshop drawers.
Each container model is named by the outside dimensions.
Printing Instructions:
Print from any material you like (PLA/PETG/ABS), my drawers are from whatever was left on the spools - PLA and PETG
Infill: 15% or more (does not make much of a difference with more than 2 perimeters)
Perimeters: 2 - absolute minimum, 3 recommended
No supports nor bridging is neccessary
Brim is HIGHLY RECOMMENDED for the larger boxes, as wide as you can, to avoid warping (I used 5mm brim on textured PEI surfaces)
Please leave sugegstions in the comments/makes section, I can updload more heights of the model if needed.
For any use, it took me only a few minutes to draw it in TinkerCAD, I just happened to forget about it and never published this project. Print and remix at your own pleasure! :-)