Mug Valais isotherm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple coffee mug with the Valais flag. The cup is quite wide to prevent the surface to become too hot.
Size it to your convenance, since the model is quite small and the wall are very large (oversize it).
No support or raft needed. I print it with green-tech pla because it's foodsafe and handle the temperature quite well.
Don't put to much infill to have a good air-insulation but be sure to have at least 3 walls inside and at the bottom.
NB : the flag is on the rear of the mug (my bad for the prevew ^^)
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.20
Infill:
10
Filament: Purefill PLA grey Custom Section ==============
Category: Kitchen & Dining