RaspberryPi Camera 3 corner holder - minimalistic
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A very simple screw-in holder for the RaspberryPi Camera Module 3
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 122
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Summary
Three simple holders if you want to attach a RaspberryPi Camera Module 3 in any corner so it observes the room. The camera module 3 is attached using four little screws (hole diameter 2mm) so screws of around 5mm depth and 2.5mm OD work perfectly. The holder itself can be attached using a single countersunk screw.
How To Print
You can print at 0.2mm with Quality High - at least that is how I did it. I recommend printing with the face of the structure that has the countersunk hole in it on the print plate. However, any orientation should work (even if not as nicely due to the overhang)
Contents
- 45° Angle. If the hole for the wall screw isn't on the face you need it to be at, mirror in your slicer
- 35° Angle - Hole on slim slide. Mirror in slicer if needed - this is the version shown in the example I posted.
- 35° Angle - Hole on wide slide. Mirror in slicer if needed.