Parametric suitcase whole roller handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement handle for any roller suitcase. Except that it's only half parametric, and may not fit.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 57
- Wydruki
- 1
- Wyświetlenia
- 312
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have seen two of these get destroyed, which required buying a whole new suitcase each time. I wanted to design something that could extend the life of the suitcase, as there wasn't anything else available.
I've uploaded the Fusion360 file, as although I've tried to make it parametric, it's not yet fully ready and you will probably need to step through each item to adjust things. The first few steps should be relatively parametric, the rest not so much. I do intend to fix this at some point.
The photos will be of my first test print, which did not fit the suitcase - I had measured the gap between the metal posts incorrectly. The files are for version 2, which I have not yet printed - but I will upload photos as soon as I have done. This should also have a bit looser fitment than v1, which was somewhat tight.
Notes:
Has holes for square metal poles. If you have different shapes, this should work so long as the front and back are flat.
Measure the width and depth of the metal poles, and the gap between them. Decide your wall thickness (default 2mm). Measure the distance of the screwhole from the top of the post. decide the total height of the handle, and the height of the grip.
There is also a test print that can be made, to save time and material.
I have not tested this with different scales yet.
I have not printed this version.