1 / 6
Tiny Christmas ornaments for beard and hair — zdjęcie 1
1 / 6

Tiny Christmas ornaments for beard and hair

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A tiny Christmas bauble and cone, printable without supports. Grab some hairpins for a festive self-decoration!🎄🎅

Ocena
5 / 5
Polubienia
184
Pobrania
375
Wydruki
2
Wyświetlenia
2714
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

 Christmas ornaments for beard and hair

 

These tiny ornaments will turn You into a festive decoration! 😁
 

Assembly instructions

Simply clip the base into the cone or sphere and insert a hairpin into the base's loop.

Use a big hairpin that allows the base to move more or less freely within. If too tight, the loop might break.

In case you only have small hairpins, you can use a pair of pliers to widen them.

Last step: Decorate yourself 😎

 

Chose the base of the ornaments

The base comes in two versions: base_clips.stl and base_snug.stl.  Both versions fit for both, cone and sphere. 

The first base will clip into the notch of the ornaments using a little force. It then allows to spin them, which I think is a nice effect. However, the clip mechanism is really prone to breaks during attachment (some materials are more brittle than others). And once attached, you cannot remove the base from the ornaments without breaking it. So print a few bases, just in case. Carefully using a lighter to temporarily soften the base prior to attachment also worked for me.

The second version will work just fine as well. It fits snuggly onto the decorations and the friction should ensure a secure hold. If too loose, you can add a droplet of superglue in between. This base is the “safe version” and less prone to breaks. 

 

Enjoy and Merry Christmas!

 

Print settings

MaterialPLA, PETG, or other. Color is more important ;-)
Layer height0.2mm works fine
Orientation

Print all models in an upright position!

I recommend printing the cone and the sphere individually.

You can print several bases at once.

SupportsNo supports required
Other settings Printing the cone and sphere is challenging. I recommend using a brim of ~3mm and reduce the printing speed to ~70%!
Optional

You can also play around with Prusa Slicer and mirror the cone to add some variety.

Or cut the sphere and add a fuzzy skin to one half: 

 

 

 

 

 

Tagi